1. 0445020291 Top Fuel Pump Packaging Dimensions
Pic No.1
| NO. | Name | Top Fuel Pump Packaging Size (Cm) |
| 1 | Top Fuel Pump Packaging Box | 32*24*27 |
2. 0445020291 Top Fuel Pump Technical Support
2.1. 0445020291 Top Fuel Pump Utilized Location
- Example: The code of the Top Fuel Pumpis shown as follows
Pic No.2
| NO. | Name |
| A | brand, logo, part number |
2.2. Reasons of 0445020291 Top Fuel Pump Not Working Normally
(1) There is air in the oil circuit of the engine fuel system.
(2) Vehicle top fuel pump oil supply system is not normal.
(3) Engine common rail system oil leakage or pressure limiting valve damage.
(4) There is a short circuit, cutting out and poor contact in the wiring harness connected to the top fuel pump of the vehicle.
(5) The long-term placement of the top fuel pump causes the anti-rust oil to solidify, and the internal components are stuck or the oil holes are blocked.
- Before installing, carefully check whether other components in the common rail system are damaged so as to prevent the top fuel pumpfrom not working properly after being replaced.
2.3. 0445020291 Top Fuel Pump Storage Standards
(1) Choose a suitable storage place
The warehouse and cargo yard where the top fuel pumps are stored should be kept clean and dry, and away from the factory buildings that generate harmful gases and dust; do not mix with acid, alkali, salt and other substances; the storage place should have a good drainage system; the cargo yard should be flattened with gravel or furnace ash etc. to enhance the water permeability of the surface layer to keep the reservoir area dry.
(2) Strict storage requirements
Strict inspections should be carried out when the top fuel pumps are put into storage, the surface cleaning work should be done well to remove water traces, oil stains, ash and other dirt, remove the rust and do anti-rust treatment in time. Packaged top fuel pumps must be protected from damage.
(3) Keep the warehouse dry and do moisture-proof work
The relative humidity is usually below 70% for the top fuel pumps placed in the room, and the corrosion of the top fuel pumps is significantly reduced.
Top fuel pumps must be stored in the warehouse, and they are forbidden to store in the same warehouse with commodities with high water content.
(4) Reasonable stacking
After the top fuel pump is exposed to rain, the corrosion rate will increase significantly. The purpose of sealing is to isolate the top fuel pump from rainwater and humid air, so the warehouse window should be checked in time to avoid rainwater entering the warehouse.
If the top fuel pump package is damaged, it should be repaired or replaced; when the package is damp, the packaging material should be dried; if the original anti-corrosion and oil applied at the factory is found to be damaged or dried up, it should be cleaned and re-applied oil in time.
- It is forbidden to leave the top fuel pumpexposed in the air for a long time.
- It is forbidden to store acid, alkali, salt and other substances together with the top fuel pump.
- The unpacked top fuel pumpmust be rust-proof during secondary storage.
4. Copyright Statement
The material “0445020291 Top Fuel Pump Encyclopedia” is the exclusive property of www.topfuelpump.com and Shenzhen Shumatt Technology Co., Ltd., and it is protected by copyright law. Any unauthorized use of this material is strictly prohibited. This includes, but is not limited to, copying, reproducing, distributing, modifying, adapting, translating, or creating derivative works based on the content of this document. Additionally, it is not permitted to use this material in any form of public display, performance, or transmission without obtaining prior written consent from www.topfuelpump.com.
Failure to comply with these requirements may result in legal action. www.topfuelpump.com reserves all rights to pursue legal remedies for any infringement of its copyright.
For any inquiries about using the passage, please contact hison@shumatt.com.
